Latex Balloons fill - Ultra Hi-Float

Ultra Hi-Float Pint (473ml) (Will coat approx 100 x 28cm Latex Balloons) - Each
At to cart at the bottom of the page.

Ultra Hi-Float Pint (473ml)  (Will coat approx 100 x 28cm Latex Balloons) ULTRA HI-FLOAT is a liquid plastic solution that dries inside a balloon to form a coating that holds in Helium. It makes latex balloons float up to 25 times longer! Before use, read these instructions and warnings and the troubleshooting guide on the reverse side. Using Hi-Float in your Balloons will allow you to decorate the Party the night before ( without the worry of filling balloons on the day of the party). Most of today's Quality Latex Helium Balloons have a float life of 14 to 16 hours. Hi-float is perfect to save time. It takes a few hours after inflation for the ULTRA HI-FLOAT to dry enough so that it will not splatter if the balloon bursts. Although it is not toxic, the wet ULTRA HI-FLOAT is like the adhesive on envelopes and could cause damage if it splattered onto furniture or surfaces such as walls. Therefore, it is recommended to inflate the balloons and keep them away from such surfaces for the first few hours after inflation. If this is not possible, cover the immediate area with drop cloths. For added safety, glasses or safety goggles are recommended when inflating treated balloons to avoid eye contact. If ULTRA HI-FLOAT contacts the eye, flush with water for several minutes. If irritation persists, consult a physician.
INSTRUCTIONS FOR USE
Place the pump into the bottle and tighten the threaded cap. Turn the top of pump counterclockwise to unlock the nozzle. For the first use only, hold a cup under the pump and press several times until liquid comes out. Slide the balloon opening over the pump outlet nozzle as far as it will go in order to inject ULTRA HI-FLOAT deep inside the body of the balloon. (The key to mess free application of ULTRA HI-FLOAT is to keep it out of the neck of the balloon where it can drip onto your hands or the Helium nozzle. If you get ULTRA HI-FLOAT on your hands when tying the balloon, you are not injecting it deep enough inside the balloon.) Depress the pump plunger as shown in the figure to the right, following the guidelines in the table below.
Balloon Size Press Down Pump 9 inch 1/2 way 11 inch 1 time 14 inch 2 times 16 inch 3 times
Note: ULTRA HI-FLOAT is much easier to pump if the bottle is kept in a warm location. When the pump reaches the bottom of the stroke, remove the balloon from the nozzle. Pinch the neck of the balloon as you remove it to clean ULTRA HI-FLOAT off the nozzle and keep it out of the neck of the balloon. Gently rub the bulb of the balloon a couple of seconds to spread the ULTRA HI-FLOAT over the inside surface of the balloon as shown in the figure to the right. While rubbing, hold the balloon opening elevated to prevent liquid from entering the neck of the balloon. Inflate the balloon until it is slightly pear shaped. (If the balloon does not float initially, you probably need to add more Helium to inflate the balloon to a larger size.) Hand tie the balloon. (Disks and clips do not form a good seal and allow Helium to escape.) Allow the ULTRA HI-FLOAT in the balloon to dry for at least a couple of hours before moving it to a location where splattered ULTRA HI-FLOAT from a burst balloon might cause damage. Keep balloons indoors, in a heated or air-conditioned location between 72 and 80 degrees Fahrenheit, to achieve maximum float life.